Volume Pricing (Log In to see Member Pricing)
Premium 3D Printer Filament PLA 1.75mm 1kg/spool, Fluorescent Yellow
Get outstanding 3D printing results when you use 1.75mm PLA 3D Printer Filament from Monoprice!
PLA is a good choice for a printing material if you are looking for high accuracy and high resolution. It extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0.3%). PLA is harder than ABS, but is therefore also a bit more brittle.
This 1 kg spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature of 210° C (410°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament.
The negatives of using PLA is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and drooping if it gets too hot.
- Reel Diameter: 195mm (7.68")
- Hub Diameter: 95mm (3.74")
- Spindle Diameter: 38mm (1.50")
- Reel Width: 80mm (3.15")
11 months ago
5 months ago
I'm printing at 195 on the extruder and 60 on the bed for both. I have a few of the same item I want to print, so I may play with temperatures a bit and see if some other setting works better/worse.
PROS: Works well in Select Mini
CONS: Flourescent yellow's maybe harder to work with
It appears to be printing fine, but it does tend to be more difficult to get to stick to my PEI surface than Hatchbox, MeltInk and AMZ3D PLA filaments I have used before.
1 year ago