This is much smaller than the one pictured. It is actually 6 1/4" (16 cm.) This will not work as a replacement for the Maker Select Mini V2 if you want to run it all the way from the board to the hot end, but I've read that you can theoretically clip the end and solder it to the previous thermistor wire. However, it doesn't have a glass end, it has a half inch metal end that doesn't fit with the hot end if you keep the guard on the edge. All in all, it was disappointing and not was I was hoping for.

I received the wrong part, and it did not fit in my Maker Select Plus. I ended up having to order a proper replacement from a different company instead.

Comments about item not being as described are 100% accurate, but the cable you receive can still be used, it's just a bit less convenient.

After receiving the item and seeing it was unexpectedly short (maybe a quarter of the expected length), I contacted MonoPrice. I was informed that the intended procedure for installing it is to solder the thermistor to the existing wire. They also told me they do not sell the actual item pictured here.

I did install the thermistor successfully though. I haven't bothered to solder it properly yet, I stripped the wires and used electrical tape with plenty of give so it wouldn't pull out. I've printing on it for months this way, although I'm sure I'll need to attach it properly eventually.

The point is though, it works but is not at all as described here. I really think MonoPrice should fix their listing--it's acceptable to sell a part that requires soldering, but it's not acceptable to (at the same time) picture a different device with a plug that does not require soldering.

Have yet to try and install but looks nothing like what was ordered, will see if it works/fits

Wire too short. Unusable

excellent replaceent