If you're looking for ABS this is great, a bit high on the melt temp but good end product. If you're buying this with your first 3D printer, don't. Go buy some PLA (here at MP, of course) and learn the ropes on that then move on to ABS if it has something you need. Turns out PLA would have been great for everything I do without the chemical smell.

Adheres well at 250c onto PVA glue coated Kapton with an 80c bed. In open air without a part cooling fan it does reasonably well, and there's relatively little layer separation. Would probably do better in an enclosure but i don't have one to test.

The roll I got had a couple brittle points in it - nothing that caused a print to fail but they did break during handling.