Volume Pricing (Log In to see Member Pricing)
Premium 3D Printer Filament PLA 1.75mm 1kg/spool, Red
Get outstanding 3D printing results when you use 1.75mm PLA 3D Printer Filament from Monoprice!
PLA is a good choice for a printing material if you are looking for high accuracy and high resolution. It extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0.3%). PLA is harder than ABS, but is therefore also a bit more brittle.
This 1 kg spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature of 210° C (410°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament.
The negatives of using PLA is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and drooping if it gets too hot.
- Reel Diameter: 195mm (7.68")
- Hub Diameter: 95mm (3.74")
- Spindle Diameter: 38mm (1.50")
- Reel Width: 80mm (3.15")
PROS: Great price
Other than that I have had nothing but good prints out of this filament and this is my third roll.
PROS: I have had nothing but good prints out of the Monoprice PLA
CONS: Its not red. Its a really nice orange color that I actually like but its not red.
11 months ago
1 month ago
6 months ago
PROS: Goes down cleanly. Not a single bubble or surface imperfection in the whole reel, which meant clean feeds and no jams.
CONS: A little translucent for my taste. Not really suited to some applications because of that.
5 months ago