Volume Pricing (Log In to see Member Pricing)
Premium 3D Printer Filament ABS 1.75MM 1kg/spool, Bright Orange
Get outstanding 3D printing results when you use 1.75mm ABS 3D Printer Filament from Monoprice!
ABS is one of the most commonly used filament types in 3D printing. It has a high tensile strength and good overall toughness. It has a low density and is softer than PLA, which means lower weight and lower cost when printing large models. Hardness is such that no white dot appears when bending.
This 1 Kg spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.05mm. It has a nominal processing temperature of 230° C (446°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament.
The negatives of using ABS is that it can give off a white smoke with a concentrated odor. It is best to ensure that the printing room is well ventilated when using ABS.
Additionally, it has a high moisture absorption rate. Depending on the overall humidity level of the printing environment, an opened spool can absorb enough moisture after a couple of days that high temperature printing could cause bubbles or pocks in the extrusion. It is therefore recommended to not open a spool until you are ready to print and to store any unused portion with silica gel and/or an active dehumidifier to reduce the amount of moisture it can absorb.
- Reel Diameter: 195mm (7.68")
- Hub Diameter: 95mm (3.74")
- Spindle Diameter: 38mm (1.50")
- Reel Width: 80mm (3.15")
Out of several filament types that I've tested, this has been the best material for the printer.
The rafts were easily broken after the print, and the item stayed in tact.
Would buy this product again and again!
2 months ago
PROS: Cheap, nice colors
CONS: Extremely brittle
Jammed my nozzle up tight. With all but one clog I have had on this machine, I only needed to give the filament a little extra push to clear it out. Not this. The worst part is that I need to make some parts and ended up bunging my only nozzle trying to clear the obstruction. With the cost of the nozzle and lost time, it's hard see the value of this product at any price. Stupid me bought two spools.
PROS: Looks good on the spool, and portion of part I was able to print.
CONS: Couldn't get through one print before disaster struck due to clogging.
Thank you for your review and sorry to hear of the issues you have experienced with the filament. I would recommend getting in contact with our Tech Support department regarding the issue to see if there may be a solution. They would be best reached via online chat (6:00am - 6:00pm PST) or by phone at 877-271-2592 (6:00am - 5:00pm PST).