Volume Pricing (Log In to see Member Pricing)
Premium 3D Printer Filament PLA 1.75MM 1kg/spool, Crystal Clear
Get outstanding 3D printing results when you use 1.75mm PLA 3D Printer Filament from Monoprice!
PLA is a good choice for a printing material if you are looking for high accuracy and high resolution. It extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0.3%). PLA is harder than ABS, but is therefore also a bit more brittle. Additionally, PLA is a plant-based plastic, which means that it is biodegradable and gives off a slightly sweet odor, like roasting corn.
This 1 Kg spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature of 210° C (410°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament.
The negatives of using PLA is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and drooping if it gets too hot.
- Reel Diameter: 195mm (7.68")
- Hub Diameter: 95mm (3.74")
- Spindle Diameter: 38mm (1.50")
- Reel Width: 80mm (3.15")
PROS: Cheap, translucent, prints on the same temps as my usual PLA.
CONS: Not sure if this is 100% PLA, the smell is different than my other PLA, but not offensive in any way.
8 months ago
PROS: It's clear so light shines though it.
4 months ago
PROS: Prints good
CONS: Spool is wide, no resealable bag.
8 months ago
6 months ago
PROS: Prints out perfect with the Monoprice Dual
11 months ago