Volume Pricing (Log In to see Member Pricing)
Premium 3D Printer Filament PLA 1.75MM 1kg/spool, Bright Green
Get outstanding 3D printing results when you use 1.75mm PLA 3D Printer Filament from Monoprice!
PLA is a good choice for a printing material if you are looking for high accuracy and high resolution. It extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0.3%). PLA is harder than ABS, but is therefore also a bit more brittle. Additionally, PLA is a plant-based plastic, which means that it is biodegradable and gives off a slightly sweet odor, like roasting corn.
This 1 Kg spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature of 210° C (410°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament.
The negatives of using PLA is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and drooping if it gets too hot.
- Reel Diameter: 195mm (7.68")
- Hub Diameter: 95mm (3.74")
- Spindle Diameter: 38mm (1.50")
- Reel Width: 80mm (3.15")
Questions and Answers
The only problem is that there seems to be little air bubbles here and there, but it doesn't seem to cause any problems.
Also the green is almost fluorescent, so it looks pretty cool.
3 months ago
4 months ago
PROS: uniform fiber, feeds well, 200C head temp and 60C bed Ran from speeds of 50-100 without issues on the seemecnc delta orion.
Will buy again.
PROS: -Packaged nicely on a spool, sealed in a bag with desiccant.
-Tough filament, does not grind in extruder, even with lots of retractions.
-Great color, really pops.
6 months ago
2 months ago
1 month ago